Product Overview
DFN-8(2030)B (PQ008-B)This IC is a DDR5 Serial Presence Detect EEPROM with Hub function (SPD5 Hub) built in temperature sensor.
The Hub feature allows isolation of a local bus from a controller host bus. This IC contains 1024 bytes (8K-bit) of EEPROM arranged as 16 blocks of 64 bytes (512 bit) per block. Each block can be write protected via software command. Page write and sequential read are available. This IC operates with 1.8 V VDDSPD and 1.0 V VDDIO and the SidebandBus (I2C & I3C) at 12.5 MHz maximum.
Caution
This product is intended to use in general electronic devices such as consumer electronics, office equipment, and communications devices. Before using the product in medical equipment or automobile equipment including car audio, keyless entry and engine control unit, contact to ABLIC Inc. is indispensable.
Features
- JEDEC standard compliant
- SPD5118
- Two-wire I2C or I3C bus serial interface
- Operation voltage range (VDDSPD)
- 1.7 V to 1.98 V
- Operation voltage range (VDDIO)
- 0.95 V to 1.05 V
- Operation frequency
- I2C: 1.0 MHz max. (VDDSPD = 1.7 V to 1.98 V)
- I3C: 12.5 MHz max. (VDDSPD = 1.7 V to 1.98 V)
- 1.0 V Push Pull I/O levels
- 1.0 V and 3.3 V Open Drain I/O levels
- Operation temperature range
- Ta = −40°C to +125°C
- Operation temperature range (NVM Write Operation)
- Ta = -40°C to +95°C
EEPROM
- Page write
- 16 bytes / page
- Sequential read
- Write protect function during low power supply voltage
- Write protect
- Individual software data protection for each of 16 blocks of 64-bytes per block
- Endurance
- 105 cycle / word*1(Ta = -40°C to +95°C)
- Memory capacity
- 8 K-bit
- Initial delivery state
- FFh
Temperature sensor
- Temperature accuracy
- 0.5°C typ. (Ta = +75°C to +95°C)
1.0°C typ. (Ta = +40°C to +125°C) - Temperature sample rate
- 8 samples / s min.
- hysteresis width
- 1.0°C
Hub Function
- Interfaces to I2C/I3C buses which have multiple devices on a shared bus
- Uniquely addressed with fixed addressing on the same bus.
- All Hubs respond to specific predefined I2C/I3C device select codes on a host interface bus
- Integrates a second local I2C/I3C bus and passes through of commands from host bus onto local bus for addressing of I2C/I3C devices on local bus
Overall
- Current consumption
- EEPROM in standby mode and temperature sensor in active mode: 0.15 mA max.*2
EEPROM in read operation mode and temperature sensor in active mode: 2.0 mA max.*2
EEPROM in write operation mode and temperature sensor in active mode: 3.0 mA max.*2 - Noise suppression
- Schmitt trigger on input pins (HSCL, HSDA, LSDA)
Noise filter on input pins at I2C (HSCL, HSDA) - Packet Error Check (PEC) function
- Parity Error check function
- In Band Interrupt (IBI)
- Bus Reset function
- Up to 8 unique addressing
- 9-pin thermally enhanced DFN package
*1. For each address (Word: 8-bit)
*2. VDDSPD = 1.8V