ABLIC’s convenience timer is a CMOS timer IC with ultra-low power consumption, which is suitable for...

A wake-up timer IC is an IC that enables intermittent system operation by periodically waking up the...

A wake-up timer IC is an IC that enables intermittent system operation by periodically waking up the...

Since we do not assume the use of connecting an oscillator to XIN/XOUT, please do not use it in such...

Since self-heating is extremely low, there are no problems with power dissipation and thermal resist...

Please contact each quartz crystal maker for matching evaluation.

We have lineup below. S-35710C01x-K8T2U with a CL = 6 pF. S-35710B01x-K8T2U with a CL = 9 pF.

IC-to-IC frequency deviation is ±1%. This IC contains a quartz crystal. The frequency deviation of a...

We have a lineup of S-35710M with built-in quartz crystal. Please refer to S-35710M for details.

The interface of this IC is reset normally and the master device can make normal communication if ph...

If the rise time and voltage are specified in the datasheet, power on this ICs according to the rise...

The time and real-time data cannot be set. You can only set the elapsed time/relative time, such as ...

It is an IC with the same function, just with a different name depending on the application. It is a...

Since we do not assume the use of connecting an oscillator to XIN/XOUT, please do not use it in such...

Since self-heating is extremely low, there are no problems with power dissipation and thermal resist...

Please contact each quartz crystal maker for matching evaluation.

We have lineup below. S-35710C01x-K8T2U with a CL = 6 pF. S-35710B01x-K8T2U with a CL = 9 pF.

IC-to-IC frequency deviation is ±1%. This IC contains a quartz crystal. The frequency deviation of a...

We have a lineup of S-35710M with built-in quartz crystal. Please refer to S-35710M for details.

The interface of this IC is reset normally and the master device can make normal communication if ph...

If the rise time and voltage are specified in the datasheet, power on this ICs according to the rise...

The time and real-time data cannot be set. You can only set the elapsed time/relative time, such as ...

It is an IC with the same function, just with a different name depending on the application. It is a...

ABLIC’s convenience timer is a CMOS timer IC with ultra-low power consumption, which is suitable for...

If the rise time and voltage are specified in the datasheet, power on this ICs according to the rise...

When the set alarm time comes, it outputs Lo from the INT pin. As a result, the power supply can be ...

The interface of this IC is reset normally and the master device can make normal communication if ph...

ABLIC's RTCs initializes at the same time when the power supply voltage is raised. If the rise time...

It is recommended to connect to VDD or VSS pin.

If the error range is ±10 ppm, it can be calculated below. ±10ｘ10-6ｘ60secｘ60minｘ24hourｘ30day = ±25.9...

Since it is a CMOS output pin, leaving it no connect (open) is OK if LOOP is not used.

This IC does not count clocks during I2C communication. For details, refer to " External Clock Signa...

This counter reset is performed on the falling edge of RST pin. Therefore, there is no time designat...

The counter value can be reset by setting the RST pin to Lo.

The interface of this IC is reset normally and the master device can make normal communication if ph...

It's possible. Please set 32kHz output by register setting. Alternatively, we also have the S-35192...

Yes. There is a product called S-35391 with a different device code from S-35390, so please consider...

Since we do not assume the use of connecting an oscillator to XIN/XOUT, please do not use it in such...

Since self-heating is extremely low, there are no problems with power dissipation and thermal resist...

Please contact each quartz crystal maker for matching evaluation.

Cg is recommended from none to 9.1pF. The crystal oscillation circuit operates even when Cg is not c...

When using the quartz crystal with a CL exceeding the rated value (7 pF) (e.g: CL = 12.5 pF), oscill...

There is no RTC with built-in quartz crystal. Although it is not RTCs, we have a wake-up timer IC wi...

There is no backup battery connect pin. Even without this pin, by inserting a diode between the main...

In the system which operates with a backup battery, the included free registers can be used as the f...

The function of clock correction is to correct advance / delay of the clock due to the deviation of ...

It can be set with a product called S-35399.